General provision: It's available for titanium and titanium alloy pipes used in ships and marine engineering. If the other material is used, it must be reviewed by CCS about chemical composition, mechanical property and application scenarios. It can be accepted according to recognized standards if allowed.
Manufacturing: Titanium and titanium alloy pipes should be produced by factories approved by CCS. Except as provided in this section, the manufacturing and test of titanium alloy pipes should comply with the relevant provisions in Chapter 1, 2, 4. The melting of titanium and titanium alloys should be executed in vacuum. If it's smelted in a vacuum consumable furnace, twice or more remelting should be adopted to ensure the uniformity of the chemical composition and polycrystals and reduce the level of oxidation and nitridation inclusions. Titanium alloy pipes can be manufactured by rolling, welding, or both welding and rolling. Welded pipes can be annealed by plates, and welded by TIG or MIG. If the filling material is required, it should be compatible with the base material. The quality of titanium and titanium alloy pipes shall comply with the relevant provisions of 4.1.3 in Chapter 4 of this specification.
Heat treatment: Unless otherwise specified in the contract, titanium and titanium alloy pipes shall be delivered in annealed state. For cold-rolled pipes, annealing should be carried out no less than 540 ℃; For hot-rolled pipes, if the final temperature is not lower than 760 ℃, further heat treatment is not necessary.
Chemical composition: Titanium alloy factories should analyze the chemical composition on each furnace of products by melting.
Mechanical properties: Titanium tubes and titanium alloy pipes can be tested in batches. Each batch of pipes should be composed of titanium pipes with the same furnace number, manufacturing method, specification, and order of heat treatment.
No less than 2 pipes are randomly selected from each batch at a ratio of 2%, which are tested according to the following requirement: tensile test and flattening test are conducted on each pipe; If the order requested, a bent sample will be cut from each pipe. The tensile and flattening tests shall comply with the provisions of Chapter 2. During the flattening test, when the pipe diameter is less than or equal to 25.4mm, the flattening coefficient is taken as 0.04; When the diameter of the pipe is greater than 25.4mm, the flattening coefficient is taken as 0.06. For TA10 alloy, the flattening coefficient is taken as 0.04. The mechanical properties of titanium and titanium alloy pipes shall meet the requirements specified in Table 4. Non-destructive testing and hydraulic testing of mechanical properties of titanium and titanium alloy pipes: All titanium and titanium alloy pipes should undergo non-destructive testing and hydraulic testing at the manufacturing plant. Non-destructive testing can be conducted using eddy current or ultrasonic testing in accordance with recognized standards such as GB/T 12969. If there is no contract provision, the pressure for hydraulic testing can be determined according to the following formula. For pipes with a diameter less than 76mm, the pressure does not exceed 17.2 MPa; For pipes with a diameter over 76mm, the pressure does not exceed 19.3MPa. In the formula: P -- test pressure, MPa; k -- test pressure coefficient, taken as 1 for seamless pipes and 0.85 for welded pipes; S - allowable stress of the pipe, generally taken as 50% of the minimum non proportional tensile strength specified by the material, MPa; t - pipe wall thickness, mm; D - nominal outer diameter of the pipe, mm. During the hydraulic test, the test pressure should be maintained for at least 5 seconds and the pipe should not be deformed or leak.
Identification and certificate: CCS and the following symbol should be marked on each titanium pipe or titanium alloy pipe by the manufacturer: manufacturer's name or trademark; brand and specification of the material; The number or abbreviation that can trace the entire production process. Each batch of pipes should be attached with a certificate of conformity which should include: the name of the ordering party and the contract number; Material grade, furnace batch number, and delivery status; Specification and quantity of materials; Chemical composition and mechanical properties of materials.

