Jan 10, 2025

Advantages and disadvantages of hot rolling of titanium alloys

Leave a message

 Advantages of hot rolling

 Hot rolling can significantly reduce energy consumption and cost. Generally with the increase in temperature, the deformation resistance of the metal is reduced, so the deformation resistance of the metal in hot rolling is lower than in cold working, which can significantly reduce the energy consumption in rolling. Therefore, any metal that can be hot rolled to open blanks should be hot rolled.

 Hot rolling can improve the process performance of metals and alloys. Because hot rolling can be cast state of coarse grains broken, microcracks healing, reduce or eliminate casting defects.Therefore, hot rolling can transform the low plasticity of the casting state organization into a higher plasticity of the deformation organization (processing organization), to improve the processing performance of metals.

 Hot rolling can be rolled with large underpressure. In a certain temperature range, with the increase in temperature, the plasticity of the metal increases, so that a larger deformation can be used for rolling, but also to reduce the crack defects of the metal, improve the rate of metal formation.

 Hot rolling can be applied to large ingot rolling. As the metal has a high plasticity and small deformation resistance when hot rolling, available larger ingot billet. Not only can improve productivity, yield and rolling speed, but also for the continuous rolling process and automation to create the conditions.

info-548-470

Disadvantages of hot rolling

 

 Hot rolling is difficult to accurately control the mechanical properties of the product, the organization and properties of the hot rolled product is not uniform enough, the strength of the hot rolled product is lower, and the range of fluctuations in performance is large.

 The size of hot rolled products is more difficult to accurately control, the surface is rougher than that of cold rolled products, and the surface quality is not high due to easy oxidation at high temperatures. So non-ferrous metal plate and strip production, hot rolling rarely directly produce finished products, the vast majority of cold rolling to provide bad material.

info-554-296

 

 

Send Inquiry